- By default, when viewing a flat sprite from behind, the image is flipped around on the X axis. This may not always be desired, so this flag disables it.
- FLATSPRITE: An actor becomes flat as if they were a decal on the floor.
- PITCHFLATSPRITE: A flat sprite tilts up and down based on pitch.
- WALLSPRITE: Similar to a Y billboarded sprite. The degree of the flattening is determined by the FlatAngle property.
- ROLLSPRITE: The sprite of the actor is affected by the Roll property.
- ALLOWTHRUFLAGS must be used on the puffs, added for the sake of compatibility with older mods. This applies to the following:
-- Bullets: THRUACTORS, THRUSPECIES
-- Rails: Same as bullets, but includes THRUGHOST.
Note that this required splitting P_SerializeWorld, because sector_t and FSectorPortal contain some actor pointers, for which the same rule applies: Portal linking can only be done after all sectors have been read, meaning it cannot be done along with the rest of the data in these structures.
Obviously such a change breaks savegame compatibility so the min. savegame version had to be increased again.
Two issues:
Portal linking requires all skyboxes in the sectors to be present, without them some info is not there when needed.
UpdateWaterLevel was called in AActor::Serialize, which operated on the freshly loaded level where lots of things haven't been set up yet and plane heights may be wrong.
This is for rendering the sprite properly in all areas the actor touches. The original thinglist is not sufficient for this and Boom's touching thinglist has other purposes and collects too much data.
This new list will only get filled in when the actor is actually crossing a portal plane, for the normal sector thinglist will still be used.
This piggybacks on the msecnode_t code which has been extended to be able to handle more than one list by passing the sector's membert pointers as parameters.
While testing this it became clear that with the higher precision of doubles it has to be avoided at all costs to compare an actor's z position with a value retrieved from ZatPoint to check if it is standing on a floor. There can be some minor variations, depending on what was done with this value. Added isAbove, isBelow and isAtZ checking methods to AActor which properly deal with the problem.
- started converting g_hexen.
Most importantly this removes CHolyWeave as it is just a specialized version of A_Weave with far more convoluted use of parameters.
- replaced some uses of FRACUNIT with OPAQUE when it was about translucency.
- simplified some overly complicated translucency multiplications in the SBARINFO code.
