This implements a bruteforce approach for 2D line antialiasing.
It's not perfect by any means, but it seems to do its job well enough.
Since it draws 9 lines instead of 1 line per segment, it's significantly
more expensive but should still be usable on modern hardware (except
on very complex maps).
Automap line antialiasing is disabled by default and can be enabled
with the `am_lineantialiasing 1` cvar.
The minimum value was increased from 30 to 35 to reflect the lowest
value you can actually use in `vid_maxfps`. Values lower than 35
are silently clamped to 35.
The maximum value is chosen to cater to the fastest commercially
available display as of writing (500 Hz).
Being able to specify maximum FPS with a more precise slider has
several benefits:
- This adds support for monitors with less common refresh rates
(138 Hz, 165 Hz, ...).
- This adds support for monitors with very high refresh rates
(240 Hz or more).
- This allows catering to variable refresh rate setups with a FPS cap
chosen to avoid V-Sync input lag, while also avoiding tearing.
For example, choosing a FPS cap of 117 on a 120 Hz display will prevent
the display from reaching its maximum refresh rate.
More information: https://blurbusters.com/howto-low-lag-vsync-on/
- The value no longer displays a "Unknown" if customized in the console
using the `vid_maxfps` cvar.
This works similar to MAPINFO: The first definition in a file declares the format, all later ones must be the same.
This change in syntax increases robustness significantly because it avoids the problems with the original syntax not being able to detect badly formatted names.
This is mainly for new games which have been designed for hardware rendering.
Note that this does not remove the software renderer's code - all it does is to disable the vid_rendermode CVAR by turning it into a static constant with the value 4.
- changed default value for midi_config to empty string since gus is not working with sf2 file
- fixed SetupDMXGUS not loading lump correctly, wrong use of CheckNumForFullName
- midi_config default to empty string, since lzdoom.sf2 doesn't seem supported (distorted sound)
- added absolute paths to FZipPatReader so we can add custom patches to resource files by using gus_patchdir and/or ULTRADIR variable (some custom maps has custom patches that can be added this way without putting them inside the resource file or in the same folder of the configuration file)
- set timidity_reverb_level min value to 0 in menudef.txt, set to 9 by mistake?
Turns out that there's a few old maps that have the extended line flags set but not the guard bit that forces their clearance.
Astrostein 1's first map is an example for this.
This can be used to improve automap readability on high-resolution
displays.
Some automap options in the menu were reordered to follow a more
logical order.
* Added SBSLETTERBOX to menudef.txt
* Changed PresentSideBySide in gl_renderer
Needed for new side-by-side mode
* Added VR_SIDEBYSIDELETTERBOX to gl_stereo3d.cpp
For side by side letterbox display mode
* Added VR_SIDEBYSIDELETTERBOX to hw_modes.h
For new side by side letterbox display mode
* Added VR_SIDEBYSIDELETTERBOX to hw_vrmodes.cpp
For Side By Side Letterbox display mode
