Context: https://github.com/FluidSynth/fluidsynth/discussions/931
There is a new settings "audio.oboe.error-recovery-mode" which has
string value of "Reconnect" (default) or "Stop".
Under `Reconnect` mode, it automatically recreate AudioStream for the
same audio device ID (which is the default = valid device, unless a
specific ID is specified). The behavior is the same as OpenSLES.
In the future Fluidsynth might want to provide consistent error handling
mode for audio device unplugged state, but so far this change makes apps
behave not too weird.
This adds new LFO modulators:
- these modulators are computed on the fly, instead of using lfo lookup table. Advantages:
- Avoiding a lost of 608272 memory bytes when lfo speed is low (0.3Hz).
- Allows to diminish the lfo speed lower limit to 0.1Hz instead of 0.3Hz.
A speed of 0.1 is interesting for chorus. Using a lookup table for 0.1Hz
would require too much memory (1824816 bytes).
- Make use of first-order all-pass interpolator instead of bandlimited interpolation.
- Although lfo modulator is computed on the fly, cpu load is lower than using
lfo lookup table with bandlimited interpolator.
Also adds a stereo unit controlled by WIDTH macro. WIDTH [0..10] value define a stereo separation between left and right.
- When 0, the output is monophonic.
- When > 0 , the output is stereophonic.
WIDTH is currently fixed to maximum value to provide maximum stereo effect.
This set of changes implements audio drivers for Android, OpenSLES and Oboe. The changes in the original sources are kept minimal so that it should be easily maintained.
This change adds a new feature that enables loading and unloading of
sample data on demand. As soon as a preset is selected for a channel, all
of it's samples are loaded into memory. When a preset is unselected, all
of it's samples are unloaded from memory (unless they are being used by
another selected preset).
This feature is disabled by default and can be switched on with the
"synth.dynamic-sample-loading" setting.
The EMU8k/10k hardware applies a 0.4 factor to all initially set attenuation generator values. Do this once on soundfont load.
Remove the invalid -531.509 power factor that was computed from Timidiy's non-standard conversion table. And remove the synth.volenv switch again, as the "compliant" setting wasn't compliant at all.
This allows us to get rid of the atten2amp function and use cb2amp everywhere, with a range of 0 1440 centibels.
Fixes#70
Supersedes #71
Supersedes #318
