It turns out the expected orientation of the sky cube is exactly that of
Blender's default cube looked at from the front view (num-1) and the front
face being the nearest face. This put's Marcher's sun nicely in the view
when exiting the cave.
Rearrange the sky_suffix and sky_coords arrays and remove the sky_target
array such that the faces can be loaded using
GL_TEXTURE_CUBE_MAP_POSITIVE_X + i (apparently certain drivers break if
the faces aren't loaded in the correct order).
Also, the nomalization of the direction vector in the fragment isn't
necessary.
Need to subtract the size of the bsp_t/bsp29_t struct. Now old and new
qfbsp produce identical bsps (so long as they're both unoptimized, or
(probably) both optimized).
All of the nastiness is hidden in bspfile.c (including the old bsp29
specific data types). However, the conversions between bsp29 and bsp2 are
implemented but not yet hooked up properly. This commit just gets the data
structures in place and the obvious changes necessary to the rest of the
engine to get it to compile, plus a few obvious "make it work" changes.
More or less.
This is a bit of an experiment (which seems to work nicely) in that qfcc
and pak are build natively in one build tree, then the full system is
cross-built in another tree using the natively build qfcc and pak. Both
trees are created by cross-configure.sh as sub-directories of the current
directory. However, cross-configure.sh still assumes it is being run in a
subdirectory of the main quakeforge directory.
cross-make.sh checks if the native tree is in the current directory and if
so, builds it, otherwise it just runs make for the cross-build tree (this
allows for running cross-make in a sub-directory for things like sorting
out build issues).
CC_FOR_BUILD is the recommended name these days (HOST_CC was from an old
gcc version, and is confusing anyway). Also, CC_FOR_BUILD should be set by
configure.
This should make maintaining them a little easier.
The copyright block in most of the new headers (execpt vector.h) reflect
when the functions in the relevant header were first created.
Unfortunately, just because the header is there doesn't mean anything will
actually work :(. Also, the check is based on the host vendor/os for now.
Yes, it's rather lame but it will do for now.
With this, QF will build on an almost fresh ps3toolchain install. Only two
"fixes" are needed:
o In $PS3DEV/ppu/powerpc64-ps3-elf: ln -s ../include sys-include
o libsamplerate cross-built and installed.
